This remote control will live in the kitchen, the icons show that it will be possible to control the light, hood, music, set the timer. The device is based on a module from EBYTE E18-MS1-PCB or E18-MS1PA1-PCB if an increased communication range is required. The advantages of this module are cheapness and ultra-low consumption, 0.4 μA in deep sleep mode. The remote control is powered by one CR2032 element if a 2.5mW module is used, and from two elements via an LDO when using a 100mW module. There is also a LED and a buzzer on the diagram to indicate both the actual operation of the buttons and the display of service modes. The dimensions of the device are determined by buttons 12x12x7.3 mm with transparent covers, I must say on AliExpress, their choice is very limited and this is practically the only option. There is a version with contacts for surface mounting. , but you can also use such as in the picture, it is enough to “bite off” the legs flush with the body. While the boards are being manufactured, Jager engaged in the case, Satisfied with the result, Jager place an order for the boards. The upper part can also be printed, but it is much more aesthetically pleasing to cut out with a laser from plexiglass.įor fastening to a metal surface, magnets 9 x 1.5 mm are provided, with an effort they snap into place. In comparison with the IKEA TRÅDFRI remote control Held in place by friction.Īnd can be assembled for size estimation, Light transmittance 2%, enough to see the glow of the LED and hide the insides, 3mm thick. The original firmware was written by Vladislav support in the ioBroker driver was provided by Kirov Ilya for which special thanks to them.Ĭonsumption corresponds to the one declared by the manufacturer, which will allow the remote control to work from one CR2032 element from 1 to 2 years. The firmware implements both light and sound indications of pressing. There is a network presence control (if the device is out of the network, pressing the buttons is not confirmed by light and sound). Work on the functionality of the firmware continues, possibly binding, and other options will has written a new open-source firmware. The firmware added a lot of new options, binding, multi-click, etc. Significantly improved stability and made his version of the case using other buttons, 12x12 5mm high.USBasp is a USB in-circuit programmer for Atmel AVR controllers. It simplyĬonsists of an ATMega88 or an ATMega8 and a couple of passive components. Uses a firmware-only USB driver, no special USB controller is needed. No special controllers or smd components are needed.Programming speed is up to 5kBytes/sec. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |